Vapor phase doping; Atmospheric pressure chemical vapor deposition; n-Type doping
Abstract :
[en] Atomic layer doping of phosphorus (P) and arsenic (As) into Si was performed using the vapor phase doping (VPD) technique. For increasing deposition time and precursor gas flow rate, the P and As doses tend to saturate at about 0.8 and 1.0 monolayer of Si, respectively. Therefore, these processes are self-limited in both cases. When a Si cap layer is grown on the P-covered Si(001), high P concentration of 3.7 × 1020 cm-3 at the heterointerface in the Si- cap/P/Si-substrate layer stacks is achieved. Due to As desorption and segregation toward the Si surface during the temperature ramp up and during the Si-cap growth, the As concentration at the heterointerface in the Si-cap/As/Si-substrate layer stacks was lower compared to the P case. These results allowed us to evaluate the feasibility of the VPD process to fabricate precisely controlled doping profiles.
scite shows how a scientific paper has been cited by providing the context of the citation, a classification describing whether it supports, mentions, or contrasts the cited claim, and a label indicating in which section the citation was made.
Bibliography
Rochefort, C., van Dalen, R., Duhayon, N., Vanderworst, W., (2002) Proceedings ISPSD, pp. 237-240
Nguyen, N.D., Leys, F., Takeuchi, S., Loo, R., Caymax, M., Eyben, P., Vandervorst, W., (2008) ISTDM, p. 229. , presented at, Abstract book pp
Koh, K.W., Oh, H.J., Choi, H., Kurino, H., Koyanagi, M., (2002) Mat. Sci. Eng. B, 89, p. 435
Shimamune, Y., Sakuraba, M., Matsuura, T., Murota, J., (2000) Appl. Surf. Sci, 162-163, p. 390
Chiba, Y., Sakuraba, M., Murota, J., (2007) Semicond. Sci. Technol, 22, p. 118. , S
Tillack, B., (1998) Thin solid films, 318, p. 1
Sze, S.M., (1981) Physics of Semiconductor Devices, , 2nd edition, J. Wily and Sons
Yu, M.L., Vitkavage, D.J., Meyerson, B.S., (1986) J. Appl. Phys, 59, p. 4032
Murota, J., Sakuraba, M., Tillack, B., (2006) Jpn. J. Appl. Phys, 45, p. 6767
The growth rate on the primary SiGe surface is slightly higher than the growth rate on Si, because Ge-H bond is weaker than Si-H bond. However, when a few atomic layers of Si are deposited
the initial growth rate decreases and reaches a stationary value
Chang, C.-A., (1976) J. Electrochem. Soc, 123, p. 1245
Liu, X., Tang, Q., Kamins, T.I., Harris, J.S., (2003) J. Crystal Growth, 251, p. 651
Yang, M., Carroll, M., Sturm, J.C., Büyüklimanli, T., (2000) J. Electrochem. Soc, 147, p. 3541
Kipp, L., Bringans, R.D., Biegelsen, D.K., Northrup, J.E., Garcia, A., Swartz, L.-E., (1995) Phys. Rev. B, 52, p. 5843
This website uses cookies to improve user experience. Read more
Save & Close
Accept all
Decline all
Show detailsHide details
Cookie declaration
About cookies
Strictly necessary
Performance
Strictly necessary cookies allow core website functionality such as user login and account management. The website cannot be used properly without strictly necessary cookies.
This cookie is used by Cookie-Script.com service to remember visitor cookie consent preferences. It is necessary for Cookie-Script.com cookie banner to work properly.
Performance cookies are used to see how visitors use the website, eg. analytics cookies. Those cookies cannot be used to directly identify a certain visitor.
Used to store the attribution information, the referrer initially used to visit the website
Cookies are small text files that are placed on your computer by websites that you visit. Websites use cookies to help users navigate efficiently and perform certain functions. Cookies that are required for the website to operate properly are allowed to be set without your permission. All other cookies need to be approved before they can be set in the browser.
You can change your consent to cookie usage at any time on our Privacy Policy page.