Berger, N., Azéma, E., Douce, J.F., Radjai, F., Scaling behaviour of cohesive granular flows. EPL (Europhys. Lett.), 112, 2016, 64004.
Shi, H., Mohanty, R., Chakravarty, S., Cabiscol, R., Morgeneyer, M., Zetzener, H., Ooi, J.Y., Kwade, A., Luding, S., Magnanimo, V., Effect of particle size and cohesion on powder yielding and flow. KONA Powder Part. J. 35 (2018), 226–250.
MiDi, G.D.R., On dense granular flows. Eur. Phys. J. E 14 (2004), 341–365.
Jop, P., Forterre, Y., Pouliquen, O., A constitutive law for dense granular flows. Nature 441 (2006), 727–730.
Pouliquen, O., Cassar, C., Jop, P., Forterre, Y., Nicolas, M., Flow of dense granular material: towards simple constitutive laws. J. Stat. Mech., 2006, 2006, P07020.
Lumay, G., Vandewalle, N., Bodson, C., Delattre, L., Gerasimov, O., Linking compaction dynamics to the flow properties of powders. Appl. Phys. Lett., 89, 2006, 093505.
Schall, P., van Hecke, M., Shear bands in matter with granularity. Annu. Rev. Fluid Mech. 42 (2010), 67–88.
Lumay, G., Vandewalle, N., Flow of magnetized grains in a rotating drum. Phys. Rev. E, 82, 2010, 040301.
Lumay, G., Boschini, F., Traina, K., Bontempi, S., Remy, J.C., Cloots, R., Vandewalle, N., Measuring the flowing properties of powders and grains. Powder Technol. 224 (2012), 19–27.
Jarray, A., Magnanimo, V., Luding, S., Wet granular flow control through liquid induced cohesion. Powder Technol. 341 (2019), 126–139.
Casagrande, A., The determination of the pre-consolidation load and its practical significance. Proceedings of the International Conference on Soil Mechanics and Foundation Engineering, volume 3, 1936, Harvard University Cambridge, 60–64.
Jenike, A.W., Storage and flow of solids, bulletin no. 123. Bul. Univ. Utah, 53, 1964.
Schwedes, J., Vergleichende Betrachtungen zum Einsatz von Schergeräten zur Messung von Schüttguteigenschaften. Proc. PARTEC, Nürnberg, 1979, 278–300.
Schulze, D., Entwicklung und Anwendung eines neuartigen Ringschergerätes. Aufbereitungs-Technik 35 (1994), 524–535.
Shibuya, S., Mitachi, T., Tamate, S., Interpretation of direct shear box testing of sands as quasi-simple shear. Geotechnique 47 (1997), 769–790.
Schulze, D., Powders and Bulk Solids: Behavior, Characterization, Storage and Flow. 2008, Springer.
Zafar, U., Hare, C., Calvert, G., Ghadiri, M., Girimonte, R., Formisani, B., Quintanilla, M.A.S., Valverde, J.M., Comparison of cohesive powder flowability measured by schulze shear cell, raining bed method, Sevilla powder tester and new ball indentation method. Powder Technol. 286 (2015), 807–816.
Russell, A., Müller, P., Shi, H., Tomas, J., Influences of loading rate and preloading on the mechanical properties of dry elasto-plastic granules under compression. AICHE J. 60 (2014), 4037–4050.
Thakur, S.C., Ahmadian, H., Sun, J., Ooi, J.Y., An experimental and numerical study of packing, compression, and caking behaviour of detergent powders. Particuology 12 (2014), 2–12.
Imole, O.I., Paulick, M., Magnanimo, V., Morgeneyer, M., Montes, B.E., Ramaioli, M., Kwade, A., Luding, S., Slow stress relaxation behavior of cohesive powders. Powder Technol. 293 (2016), 82–93.
Morgeneyer, M., Brendel, L., Farkas, Z., Kadau, D., Wolf, D.E., Schwedes, J., Can one make a powder forget its history?. Proceedings of the 4th International Conference for Conveying and Handling of Particulate Solids, Budapest, 2003, 12–118.
Morgeneyer, M., Schwedes, J., Investigation of powder properties using alternating strain paths. Task Quart. 7 (2003), 571–578.
Feise, H., Schwedes, J., Investigation of the behaviour of cohesive powder in the biaxial tester. KONA Powder Part. J. 13 (1995), 99–104.
Zhou, Y.C., Xu, B.H., Yu, A.B., Zulli, P., An experimental and numerical study of the angle of repose of coarse spheres. Powder Technol. 125 (2002), 45–54.
Ileleji, K., Zhou, B., The angle of repose of bulk corn stover particles. Powder Technol. 187 (2008), 110–118.
Grey, R., Beddow, J., On the Hausner ratio and its relationship to some properties of metal powders. Powder Technol. 2 (1969), 323–326.
Traina, K., Cloots, R., Bontempi, S., Lumay, G., Vandewalle, N., Boschini, F., Flow abilities of powders and granular materials evidenced from dynamical tap density measurement. Powder Technol. 235 (2013), 842–852.
Liu, X.Y., Specht, E., Mellmann, J., Experimental study of the lower and upper angles of repose of granular materials in rotating drums. Powder Technol. 154 (2005), 125–131.
Pirard, S.L., Lumay, G., Vandewalle, N., Pirard, J.-P., Motion of carbon nanotubes in a rotating drum: the dynamic angle of repose and a bed behavior diagram. Chem. Eng. J. 146 (2009), 143–147.
Nalluri, V.R., Kuentz, M., Flowability characterisation of drug–excipient blends using a novel powder avalanching method. Eur. J. Pharm. Biopharm. 74 (2010), 388–396.
Ahn, H., Başaranoğlu, Z., Ylmaz, M., Buğutekin, A., Gül, M.Z., Experimental investigation of granular flow through an orifice. Powder Technol. 186 (2008), 65–71.
Freeman, R., Measuring the flow properties of consolidated, conditioned and aerated powders - a comparative study using a powder rheometer and a rotational shear cell. Powder Technol. 174 (2007), 25–33.
Madariaga, L.F., Marchal, P., Castel, C., Favre, E., Choplin, L., Characterization of impregnated particles via powder rheology. Powder Technol. 196 (2009), 222–228.
E. P. Commission, E. D. for the Quality of Medicines & Healthcare. European pharmacopoeia 7.0, Chapter 2.9.36 : Powder flow, volume 1, 2010, Council of Europe.
Feise, H.J., A review of induced anisotropy and steady-state flow in powders. Powder Technol. 98 (1998), 191–200.
Zetzener, H., Schwedes, J., Relaxation and creep of dry bulk solids. Part. Part. Syst. Charact. 19 (2002), 144–148.
Al-Hashemi, H.M.B., Al-Amoudi, O.S.B., A review on the angle of repose of granular materials. Powder Technol. 330 (2018), 397–417.
ASTM-D6773–-16, Standard Shear Test Method for Bulk Solids Using the Schulze Ring Shear Tester. 2008, ASTM International, West Conshohocken, PA.
Félix, G., Falk, V., D'Ortona, U., Granular flows in a rotating drum: the scaling law between velocity and thickness of the flow. Eur. Phys. J. E 22 (2007), 25–31.
Brewster, R., Grest, G.S., Levine, A.J., Effects of cohesion on the surface angle and velocity profiles of granular material in a rotating drum. Phys. Rev. E, 79, 2009, 011305.
Cheng, N.-S., Zhao, K., Difference between static and dynamic angle of repose of uniform sediment grains. Int. J. Sediment Res. 32 (2017), 149–154.
Lajeunesse, E., Mangeney-Castelnau, A., Vilotte, J., Spreading of a granular mass on a horizontal plane. Phys. Fluids 16 (2004), 2371–2381.
Liu, Z., Measuring the angle of repose of granular systems using hollow cylinders. Ph.D. thesis, University of Pittsburgh, 2011.
Al-Hashemi, H.M., Bukhary, A.H., Correlation between california bearing ratio (cbr) and angle of repose of granular soil. Electron. J. Geotech. Eng. 21 (2016), 5655–5660.
