Publications of Raphaël Closset
Bookmark and Share    
Full Text
See detailMagnetic shielding performances of YBa2Cu3O7−δ -coated silver tubes obtained by electrophoretic deposition
Devendra Kumar, N; Closset, Raphaël ULiege; Wera, Laurent ULiege et al

in Superconductor Science and Technology (2015), 28

We report a complete procedure to achieve multilayer YBCO thick films by electrophoretic deposition on silver tubes using a suspension of YBCO powder in butanol. With the aim to optimize the magnetic ... [more ▼]

We report a complete procedure to achieve multilayer YBCO thick films by electrophoretic deposition on silver tubes using a suspension of YBCO powder in butanol. With the aim to optimize the magnetic shielding performances of the coatings, we have carried out an extensive investigation of the influence of the deposition parameters, the multilayer deposition sequence and the intermediate/final heat treatments on the coating microstructure. Using the optimized conditions, a 24-layer YBCO coating has been successfully prepared on an 80 mm long Ag tube: the melt growth processed multilayered YBCO thick film thus obtained can shield an applied magnetic field of 1.9 mT at 77 K, the highest value per thickness unit reported so far in the literature for these materials. [less ▲]

Detailed reference viewed: 80 (31 ULiège)
Full Text
See detailYBa2Cu3O7-δ thick films for magnetic shielding: Electrophoretic deposition from butanol-based suspension
Closset, Raphaël ULiege; Kumar, Devendra; Wera, Laurent ULiege et al

in Materials Letters (2014), 119

Multilayered YBa2Cu3O7-δ (YBCO) thick films were coated on silver substrates by electrophoretic deposition (EPD) followed by heat treatment. A butanol-based YBCO suspension is used instead of the common ... [more ▼]

Multilayered YBa2Cu3O7-δ (YBCO) thick films were coated on silver substrates by electrophoretic deposition (EPD) followed by heat treatment. A butanol-based YBCO suspension is used instead of the common acetone-iodine combination. Tests with several dispersing agents reveal that a branched polyethyleneimine (PEI) dispersant develops large positive surface charge on suspended YBCO particles. As a demonstration of the performance of this new suspension formulation, a 12-layer 100 μm-thick YBCO coating was deposited on an Ag tube. The superconducting transition is sharp with onset critical temperature at 92 K. The sample can shield a magnetic field of ~1.3 mT at 77 K, i.e., the best value so far for an YBCO coating on a metallic substrate. © 2013 Elsevier B.V. [less ▲]

Detailed reference viewed: 96 (42 ULiège)
Full Text
See detailAC vs. DC electrophoretic deposition of hydroxyapatite on titanium
Ozhukil Kollath, Vinayaraj ULiege; Chen, Qiang; Closset, Raphaël ULiege et al

in Journal of the European Ceramic Society (2013), 33(13-14), 27152721

In this study, electrophoretic deposition (EPD) of hydroxyapatite (HA) powder on titanium plate was performed using butanol as solvent under direct current (DC) and alternating current (AC) fields. The ... [more ▼]

In this study, electrophoretic deposition (EPD) of hydroxyapatite (HA) powder on titanium plate was performed using butanol as solvent under direct current (DC) and alternating current (AC) fields. The zeta potential of the suspensions was measured to define their stability and the charge on the particles. Coating thickness was varied by adjusting the voltage and time of deposition. Surface morphology and cross section thickness were studied using scanning electron microscopy and image analysis software. Surface crack density was calculated from the micrographs. The results showed that the samples of similar thickness have higher grain density when coated using AC as compared to DC EPD. This facile but novel test proves the capability of AC-EPD to attain denser and uniform HA coatings from non-aqueous medium. [less ▲]

Detailed reference viewed: 42 (10 ULiège)
See detailYBCO superconducting thick films: electrophoretic deposition (EPD) on non-planar silver substrates
Namburi, Devendra Kumar ULiege; Closset, Raphaël ULiege; Fagnard, Jean-François ULiege et al

Conference (2013, January 30)

A new formulation of a stable YBa2Cu3O7-δ (YBCO) suspension is proposed in which butanol is preferred to the commonly-used acetone as the suspension medium. Appropriate surfactant has been used to develop ... [more ▼]

A new formulation of a stable YBa2Cu3O7-δ (YBCO) suspension is proposed in which butanol is preferred to the commonly-used acetone as the suspension medium. Appropriate surfactant has been used to develop the superficial charge on the YBCO particles in order to promote migration during the process of electrophoresis. YBCO thick films were deposited on silver tubes and half-tubes by electrophoretic deposition (EPD). The EPD parameters (deposition voltage, deposition time, number of layers etc.) were optimized with respect to the microstructural properties of the YBCO layers after an intermediate heat treatment at 920°C. An essential criterion is the minimization of macrocracks after the 920°C heat treatment, since it was found to favour good superconducting properties after the final heat treatment. This final heat treatment involves (i) partial melting above the peritectic temperature, (ii) peritectic recombination at lower temperature and (iii) reoxygenation at 500°C. Finally, the superconducting properties of the best films are discussed. A uniformly coated 55μm-thick YBCO film on a curved Ag substrate showed excellent superconducting properties with the onset of critical temperature at 92.2 K and an associated sharp resistive transition with transition width < 1 K. [less ▲]

Detailed reference viewed: 155 (48 ULiège)
See detailYBa2Cu3O7-x thick films on silver tubes for magnetic shielding applications
Namburi, Devendra Kumar ULiege; Closset, Raphaël ULiege; Fagnard, Jean-François ULiege et al

Conference (2012, December 07)

YBa2Cu3O7-x (YBCO) thick films are investigated for magnetic shielding applications at low frequencies (< 1 kHz). This requires deposition of YBCO on curved substrates such as tubes, half-tubes or even ... [more ▼]

YBa2Cu3O7-x (YBCO) thick films are investigated for magnetic shielding applications at low frequencies (< 1 kHz). This requires deposition of YBCO on curved substrates such as tubes, half-tubes or even more complex shapes. Electrophoretic Deposition (EPD) is an efficient method to achieve this goal: positively-charged YBCO particles suspended in a non aqueous medium drift towards the substrate, used as negative electrode for the application of the electric field. A crucial point is then to optimize the heat treatment of the as-deposited layers in order to achieve suitable superconducting properties. In the present work, we have developed a new suspension formulation in butanol, using a suitable surfactant to stabilize the suspension of YBCO powder (grain size < 2 µm). The EPD parameters (deposition voltage, deposition time, number of layers,...) have been selected to provide uniform layers of YBCO on silver substrates of various shapes. In the proposed communication, we shall discuss in detail the optimization of the heat treatments to achieve densification, peritectic recombination and oxygenation of the YBCO thick films deposited on silver. Scanning electron microscopy coupled with energy dispersive analysis was extensively used to characterize the (i) density / porosity, (ii) presence of macro-cracks, (iii) thickness uniformity, (iv) secondary phase content. We shall then present the characterization of the superconducting properties of the best films. Typically, a uniformly coated 55μm-thick YBCO film on a curved Ag substrate shows a magnetic Tc onset at 92.2 K and sharp resistive transition (< 1K). [less ▲]

Detailed reference viewed: 62 (19 ULiège)
Full Text
See detailStudy of the effect of a silver nanoparticle seeding layer on the crystallisation temperature, photoinduced hydrophylic and catalytic properties of TiO 2 thin films deposited on glass by magnetron sputtering
Limage, H.; Tichelaar, F. D.; Closset, Raphaël ULiege et al

in Surface & Coatings Technology (2011), 205(13-14), 3774-3778

The optimization of the photocatalytic activity and hydrophilic conversion of TiO 2 is an active research area in the field of self-cleaning materials and energy storage/conversion. One major focus is the ... [more ▼]

The optimization of the photocatalytic activity and hydrophilic conversion of TiO 2 is an active research area in the field of self-cleaning materials and energy storage/conversion. One major focus is the crystalline phase of TiO 2, known to be the most efficient of the anatase structures. Another issue is the decoration of TiO 2 with noble metals, which act as charge carrier traps for electrons. The latter hinders or reduces the electron-hole recombination rate and often leads to a more efficient photocatalytic activity. In this paper, we describe how an interlayer consisting of 3-4nm silver nanoparticles (Ag-NPs) promotes TiO 2 anatase crystallisation and has a positive effect on the photoinduced catalytic and hydrophylic properties of TiO 2 thin films. Ag-NPs and TiO 2 were deposited by magnetron sputtering in the same reactor in a two-step process: a) condensation of Ag-NPs produced in the gas phase thanks to a high-pressure discharge, and b) conventional TiO 2 magnetron deposition in oxide mode. Four temperatures from RT to 288°C were investigated and film thickness was 80nm. Particle size and film structure were determined by TEM, HRTEM and XRD. Photocatalytic activities of the samples were tracked by the evaluation of the surface hydrophilicity after UV illumination and 24. hours post-illumination, and by UV-induced palmitic acid degradation. © 2011. [less ▲]

Detailed reference viewed: 33 (4 ULiège)