S.R.P. connection; S.R.C. connection; ductility; energy dissipation; cyclic loading
Abstract :
[en] The present study intended to evaluate the dynamic behaviour of steel ring filled with compressive plastic (S.R.P.) or high-performance fibre-reinforced cementitious composites (S.R.C.) situated at the intersection of the braces. High-performance fibre-reinforced cementitious composites and plastic materials, associated with steel ring connection, seem to be helpful to dissipate the energy through braces better. Therefore, in this paper, the behaviour of S.R.C. and S.R.P. connections was analyzed under cyclic loading. Results showed a steady and relatively wide hysteresis curve for both connections, where the tensile ductility factors of S.R.P. and S.R.C. connections were found to be equal to 2.77 and 13.66, respectively. However, in general, the plastic ring, being operated efficiently to delay appearing the inelastic zone in the S.R.P. connection, was proved to outperform the HPFRCC material in the S.R.C. connection. In addition, numerical results revealed that maximum tensile and compressive loads of S.R.P. connection made with ST52 steel ring were found to be 14% and 10.7%, respectively, higher than those of S.R.P. connection made with ST37 steel ring.
Disciplines :
Civil engineering
Author, co-author :
Kazemi, Mostafa ; Université de Liège - ULiège > Département ArGEnCo > Département ArGEnCo
Kafi, Mohammad Ali
Hajforoush, Mohammad
Kheyroddin, Ali
Language :
English
Title :
Cyclic behavior of steel ring filled with compressive plastic or concrete, installed in concentric bracing system
Abbasnia, R., Vetr, M. G. H., Ahmadi, R., & Kafi, M. A. (2008). Experimental and analytical investigation on the steel ring ductility. Sharif Journal of Science and Technology, 52, 41–48.
Andalib, Z., Kafi, M. A., Kheyroddin, A., & Bazzaz, M. (2014). Experimental investigation of the ductility and performance of steel rings constructed from plates. Journal of Constructional Steel Research, 103, 77–88.
ATC-40. (1996). Guidelines for cyclic seismic testing of components of steel structures. Redwood City: Applied Technology Council.
AzariJafari, H., Amiri, M. J. T., Ashrafian, A., Rasekh, H., Barforooshi, M. J., & Berenjian, J. (2019). Ternary blended cement: an eco-friendly alternative to improve resistivity of high-performance self-consolidating concrete against elevated temperature. Journal of Cleaner Production, 223, 575–586.
AzariJafari, H., Shekarchi, M., Berenjian, J., & Ahmadi, B. (2015). Enhancing workability retention of concrete containing natural zeolite by superplasticizers’ combination. Special Publication, 302, 416–424.
Bazzaz, M., Andalib, Z., Kafi, M. A., & Khyroddin, A. (2015). Evaluating the performance of OBS-C-O in steel frames under monotonic load. Earthquakes and Structures, 8(3), 697–710.
Bazzaz, M., Kheyroddin, A., Kafi, M. A., & Andalib, Z. (2012). Evaluation of the seismic performance of off-centre bracing system with ductile element in steel frames. Steel and Composite Structures, 12(5), 445–464.
Butterworth, J. (2000). Ductile concentrically braced frames using slotted bolted joints. Structural Engineering Society New Zealand, 13, 39–48.
DIN 931-1. (1986). M1.6 to M39 hexagon cap screws partially threaded. Berlin: Deutsches Institut für Normung.
FEMA 356. (2000). Prestandard and commentary for the seismic rehabilitation of buildings. Washington: FEMA.
Gajan, S., & Saravanathiiban, D. S. (2011). Modeling of energy dissipation in structural devices and foundation soil during seismic loading. Soil Dynamics and Earthquake Engineering, 31(3), 1106–1122.
Gholhaki, M., Kheyroddin, A., Hajforoush, M., & Kazemi, M. (2018). An investigation on the fresh and hardened properties of self-compacting concrete incorporating magnetic water with various pozzolanic materials. Construction and Building Materials, 158, 173–180.
Grigorian, C. E., Yang, T. S., & Popov, E. P. (1993). Slotted bolted connection energy dissipaters. Earthquake Spectra, 9(3), 491–504.
Hajforoush, M., Madandoust, R., & Kazemi, M. (2019). Effects of simultaneous utilization of natural zeolite and magnetic water on engineering properties of self-compacting concrete. Asian Journal of Civil Engineering, 20(2), 289–300.
Hemmati, A., Kheyroddin, A., Sharbatdar, M., Park, Y., & Abolmaali, A. (2016). Ductile behavior of high-performance fiber reinforced cementitious composite (HPFRCC) frames. Construction and Building Materials, 115, 681–689.
Hibbitt, D., Karlsson, B., & Sorensen, P. (2011). ABAQUS standard user’s manual. Version (6.11-3). Dassault Systemes Simulia Corp. Providence, Rhode Island, USA.
Jahandari, S. (2015). Laboratory study of moisture and capillarity impact on lime concrete resistance due to the increase of ground water level. MSc thesis, Faculty of Civil and Surveying Engineering, Department of Geotechnical Engineering, Graduate University of Advanced Technology, Kerman, Iran.
Jahandari, S., Li, J., Saberian, M., & Shahsavarigoughari, M. (2017). Experimental study of the effects of geogrids on elasticity modulus, brittleness, strength, and stress-strain behavior of lime stabilized kaolinitic clay. GeoResJ, 13, 49–58.
Jahandari, S., Saberian, M., Tao, Z., Faridfazel Mojtahedi, S., Li, J., Ghasemi, M., et al. (2019). Effects of saturation degrees, freezing thawing, and curing on geotechnical properties of lime and lime-cement concretes. Cold Regions Science and Technology, 160, 242–251.
Khotbehsara, M. M., Miyandehi, B. M., Naseri, F., Ozbakkaloglu, T., Jafari, F., & Mohseni, E. (2018). Effect of SnO2, ZrO2, and CaCO3 nanoparticles on water transport and durability properties of self-compacting mortar containing fly ash: experimental observations and ANFIS predictions. Construction and Building Materials, 158, 823–834.
Kortiš, J., Gocál, J., Bednár, M., & Bátorek, V. (2015). Use of orthotropic plastic material for stress analysis of doubleshear-plane timber-steel structural connection. Procedia Engineering, 111, 431–435.
Madandoust, R., Bazkiyaei, Z. F. Z., & Kazemi, M. (2018). Factor influencing point load tests on concrete. Asian Journal of Civil Engineering, 19(8), 937–947.
Madandoust, R., & Kazemi, M. (2017). Numerical analysis of breakoff test method on concrete. Construction and Building Materials, 151, 487–493.
Madandoust, R., Kazemi, M., & Moghadam, S. Y. (2017). Analytical study on tensile strength of concrete. Romanian Journal of Materials, 47(2), 204–209.
Mazloom, M., Gholipour, M., & Ghasemi, M. (2019). Evaluating inelastic performance of mega-scale bracing systems in low- and medium-rise structures. Asian Journal of Civil Engineering, 20(3), 383–393.
Mualla, I. H., & Belev, B. (2002). Performance of steel frame with a new friction damper device under earthquake excitation. Engineering Structures, 24(3), 365–371.
Murthy, C. K., & Narayan, A. (2005) Application of visco-hyperelastic devices in structural response control. Masters Thesis, Virginia Polytechnic Institute and State University, USA.
Naaman, A. E., & Reinhardt, H. W. (2003). High performance fiber reinforced cement composites HPFRCC-4: international RILEM workshop Ann Arbor, Michigan. Materials and Structures, 36(264), 710–712.
Oh, S. H., Kim, Y. J., & Ryu, H. S. (2009). seismic performance of steel structures with slit dampers. Engineering Structures, 31(9), 1997–2008.
Pall, A. S., & Marsh, C. (1982). Response of Friction Damped Braced Frames. Journal of Structural Engineering, 108(ST6), 1313–1323.
Parra-Montesinos, G.J. (2000) Seismic behavior, strength and retrofit of RC column-to-steel beam connections. Report No. UMCEE 00-09, Department of Civil and Environmental Engineering, University of Michigan, Ann Arbor, Michigan, 296 pp.
Parra-Montesinos, G. J. (2005). High-performance fiber-reinforced cement composites: an alternative for seismic design of structures. ACI Structural Journal, 102(5), 668–675.
Parra-Montesinos, G. J., Peterfreund, S. W., & Chao, S. H. (2005). Highly damage-tolerant beam-column joints through use of high-performance fiber-reinforced cement composites. ACI Structural Journal, 102(3), 487–495.
Saberian, M., Li, J., & Cameron, D. (2019). Effect of crushed glass on behavior of crushed recycled pavement materials together with crumb rubber for making a clean green base and subbase. Journal of Materials in Civil Engineering, 31(7), 1–7.
Saberian, M., Mehrinejad Khotbehsara, M., Jahandari, S., Vali, R., & Li, J. (2018). Experimental and phenomenological study of the effects of adding shredded tire chips on geotechnical properties of peat. International Journal of Geotechnical Engineering, 12(4), 347–356.
Sadrmomtazi, A., Tahmouresi, B., & Saradar, A. (2018a). Effects of silica fume on mechanical strength and microstructure of basalt fiber reinforced cementitious composites (BFRCC). Construction and Building Materials, 162, 321–333.
Sadrmomtazi, A., Tajasosi, S., & Tahmouresi, B. (2018b). Effect of materials proportion on rheology and mechanical strength and microstructure of ultra-high performance concrete (UHPC). Construction and Building Materials, 187, 1103–1112.
Saghafi, M. H., Shariatmadar, H., & Kheyroddin, A. (2019). Seismic behavior of high-performance fiber-reinforced cement composites beam-column connection with high damage tolerance. International Journal of Concrete Structures and Materials, 13, 14.
Sakthivel, P. B., Govindasami, S., & Suman, N. S. (2019). Flexural performance of hybrid popropylene-polyolefin FRC composites. Asian Journal of Civil Engineering, 20, 515–526.
Saradar, A., Tahmouresi, B., Mohseni, E., & Shadmani, A. (2018). Restrained shrinkage cracking of fiber-reinforced high-strength concrete. Fibers, 6(12), 1–13.
Shanthi, R., & Jagannatha Reddy, H. N. (2019). Comparative investigation on effect of fibers in the flexural response of post tensioned beam. Asian Journal of Civil Engineering, 20, 527–536.
Tehranizadeh, M. (2001). Passive energy dissipation device for typical steel frame building in Iran. Engineering Structures, 23(6), 643–655.
Thomopoulos, K., & Koltsakis, E. (2003). Connections of CHS concrete-filled diagonals of X-bracings. Journal of Constructional Steel Research, 59(6), 665–678.
Vali, R., Khotbehsara, E. M., Saberian, M., Li, J., Mehrinejad, M., & Jahandari, S. (2019). A three-dimensional numerical comparison of bearing capacity and settlement of tapered and under-reamed piles. International Journal of Geotechnical Engineering, 13(3), 236–248.
